29″ WHEELS / 115MM REAR / 120MM FRONT

 

BUILT FOR THE UPS AND DOWNS. BUILT TO EXPLORE.

*NEW* Push ELEVENSIX-R Micro spec’d for Ranger frames. 

Revel made this bike with one thing in mind; to enjoy the ups as much as the downs. It is a Rascal, but a little lighter and faster. Revel took the legendary CBF platform somewhere it’s never been before…think XC light, XC efficiency, with the extra-high punch of that bottomless CBF feel. It is over a pound lighter than the Rascal frame and tough enough to inspire confidence on the descents. Welcome to the Ranger- a bike that takes modern XC suspension to a whole new level. Its right at home at the start line of a race, all day in the mountains or just rallying the local trails after work.

BUILD OPTIONS

FEATURES

CBF (Canflied Balanced Formula) suspension

CBF™ focuses on designing rear suspension around the Center of Curvature (CC). CBF points the chainline and corresponding drive forces around the top of the chainring through 100-percent of the travel resulting in maximum pedaling efficiency, regardless of where you are in the travel, what terrain you are on or what kind of power you’re putting down. All the power you put into the pedals goes into turning the rear wheel, allowing the suspension to do its job completely independent of drivetrain and braking forces and making the sag setting much less critical.

Carbon Layup Tech

Revel uses a mix of Japanese Toray T700 and T800 fibers in the frames, but the real magic that makes the bike so good is in the angles. Most bike frames use a selection of 0-, 45-, and 90-degree fibers, since these are the most readily available and easiest to work with. Revel optimizes their frame using more 30/60-degree fibers, which, when laid up properly, creates stronger and stiffer tubing and shapes, using less material.

Integrated Revel Chain Guide

Details! Revel wanted to create a super-stealthy, ultra-effective chain guide. This lil’ guy will hold your chain on your chainring and is super easy to adjust—all while maintaining the simplicity and clean aesthetic. Optimized around SRAM DUB cranks and BBs.

Internal Routing

Revel uses the best method for internal routing in the biz! Revel’s full-carbon tubes are molded in one piece onto the inside of the carbon frame tubes. Not only does this provide structural improvement to the frame, it also allows you to route an entire frame in about a minute. No rattling, no noise, and no fishing cables out of frames. 

PHOTOS

FRAME SPECS

 SPECS
 Wheel Size  29″
 Front Travel  120mm
 Rear Travel  115mm
 Shock Spec  190 x 45-22.2 x 8 Hardware Spec
 Boost Axles  148mm rear / 110mm front
 Seatpost Diameter  31.6mm
 Bearings  BOLU 6801 VRS full complement, 12mm x 21mm x 5mm 6pcs per bike
 Rear Brake  160mm post mount / 180mm max
 Tire Clearance  29″ x 2.6″ or 27.5″ x 2.8″ (rear)
 Bottom Bracket  Threaded (73mm English threaded)
 Tapered Headtube  IS42 upper / IS52 lower
 Colors  Johnny Green Jeans / De La Coal
 Sizes  S / M / L / XL
 Bottle Mounts  2 (small frames), 3 (med, lrg, xlrg frames)
 Frame Warranty  Lifetime Warranty(Details HERE)

 

GEOMETRY

VIDEOS